Hi
I have just started receiving calls from clients wanting to know the timing for when this will be marked as compatible. Any updates
Thanks

FYI: I installed Sage 300 2014 on Win 10 using the same steps as Win 7 (disable UAC, install using Run As Administrator, REGACC, etc) and it is working fine.
I also installed Sage 300 2016 on Win 10 without any special steps (did not disable UAC etc) and it works - Sage 300 2016 is UAC compliant.
YMMV

It's two and a half months later ... how that testing process going?

Hi William,

Thanks for the inquiry. Sage 300 2016 will support Windows 10. This was announced at Sage Summit, this past August.

Best regards,

Andrea Ainslie

Hi Andrea,

I apologize, but that is not the announcement I remember from Sage summit. I recall more along the lines that there would be a future announcement regarding supporting Widows 10, or are you specifically referring to Sage 300 v2016? Additionally, the only Sage300 KB article on the issue ID65240 has not been updated sense summit and still reads "The current supported versions Sage 300 ERP has not been tested on Windows 10 and is therefore not supported on the Windows 10 operating system.". When can we expect an official announcement from Sage regarding supporting Windows 10.

thanks,

Angel

There is no official announcement, support for Windows 10 is part of ongoing technical compliance. During my presentations at Sage Summit it was noted that we are supporting Windows 10. We currently support Sage 300 2016, as well as 2014.

Thank you,

Andrea

Thanks for the reply! Will 2014 and 2016 be the only versions supported for Windows 10 then, no 2012?

2012 and 6.0 run just fine. Turn off UAC, and run the shortcuts as Administrator.